Banner American Easy-LAM II Spécifications télécharger pdf (Page 15)

NOTE: You may want to run a test lamination first, as any item that passes

between the heat shoes will be laminated and cannot be recovered until it

exits the rear of the laminator.

7. Additional items may be fed in sequence, keeping enough distance

between sheets for trimming.

8. After the last item has exited the pull rollers, turn the motor switch

off.

9. Use the zippy cutter to cut across the film to remove the laminated

items from the unit.

10. The Easy-Lam II has mounting capability up to 3/16”. Please refer

to the video for instructions.

11. The 5 mil option switch is a factory installed option which gives

the user the capability of laminating 5 mil laminate.

Troubleshooting

The following guide will assist you with most problems that may be

encountered when laminating.

PROBLEM: Laminator is inoperative. Motor does not run and the

indicator lights are out.

ACTION: Unit may be unplugged.

Ensure that your circuit breaker has not tripped.

Fuse may have blown. Replace the fuse (in back next to

the power cord) with 15amp BUSS (MDA-15).

PROBLEM: Laminating film and item being laminated move through

the laminator erratically.

abcoffice

www.abcoffice.com

1-800-658-8788

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Banner American Easy-LAM II Spécifications Page 15