Banner American Easy-LAM II Spécifications télécharger pdf (Page 13)

counterclockwise to decrease) until the film passes over the top heat

shoe without wrinkles and the web between the laminating and pull

rollers is tight. Note: This adjustment should require only a slight turn. If

increased too much, you may stall the drive motor.

Figure 7

5. If necessary, locate the knob on the right side of the bottom supply

mandrel and adjust the tension as in Step 3 above.

Setting Heat Shoe Temperature

The laminator temperature should be adjusted according to the film

thickness and the item being laminated. See recommended temperature

settings from your film supplier. Keep in mind that different brands of

laminating film may require different temperatures.

1. Turn the heater switch on.

2. Use the thermostat adjustment knob (black knob) on the left side of

the laminator to adjust the temperature of the heat shoes.

abcoffice

www.abcoffice.com

1-800-658-8788

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Pas de commentaire

Banner American Easy-LAM II Spécifications Page 13