Banner American Easy-LAM II Spécifications télécharger pdf (Page 10)

Figure 3

2. Pull 6”-12” of film from the top roll. Pass the film under the idler

bar and safety shield, and over the heat shoes. Make sure the shiny

side of the film is against the shoes. See Figure 5 and 6.

3. For the bottom supply roll, remove the feed table. Place the

mandrel ends into position in the lower mandrel holder slots. If you

are facing the front of the laminator, the film should unwind away

from you from the bottom of the rollers as shown in Figure 4.

Figure 4

4. Pull 6”-12” of film from the bottom roll. Pass it under the lower

idler bar. You can “drop-down” the lower idler bar to give you more

clearance. After doing so, return the idler bar to its upper position for

abcoffice

www.abcoffice.com

1-800-658-8788

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Banner American Easy-LAM II Spécifications Page 10