Motor Master Switch: Cuts power to FWD/REV Switch.
Allen Key: Use to adjust film tension.
Heat Control
Your new EZSB has a digital heat controller. Users can easily adjust the set temperature for the
rollers to achieve the best quality lamination. The controller has been calibrated to accurately
display the roller temperature in the laminating range.
The heater switch on the right side cover activates the controller. When the switch is turned on
the controller will flash a two letter code and then display the roller temperature. When cold, the
temperature displayed on the controllers may be different than the actual ambient temperature to
account for correction in the higher temperature range. When the heater switch is turned on, the
controller will send power to the heaters, provided the Set Temperature is higher than ambient
temperature. (For safety reasons, this machine was shipped with the Set Temperature at 260°F).
When power is being sent to the heaters the controller will illuminate a small red indicator light in
the lower right hand corner of the display. The light goes out when the Set Temperature is
reached. Power to the heaters will cycle when the roller temperature falls below the Set
Temperature during lamination or while sitting idle.
OPERATION
This section describes the operation of your EZSB. This laminator is designed for all widths of
plastic up to 27”. However, if narrower widths are used the rollers must be cleaned before using
a wider roll. Refer to the MAINTENANCE section for cleaning instructions.
Loading Laminating Film onto Mandrels...
Slide the film onto the mandrel making sure that the mandrel spring is in position to compress
properly when the film is pushed onto the mandrel. Remove the film in the same direction. Use
the lines to center the two rolls on one another.
Threading Laminating Film...
These instructions apply to poly-in film rolls (shiny side out, dull side in)
1. For the top supply roll place the mandrel ends into the slots in the top of the laminator. If you
are facing the front of the laminator the film should unwind toward you from the bottom of the roll
as in Figure 3 on the next page.
(24 pages)
(254 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels